Network Engineer – F.O.C.U.S Follow One Course Until Successful
1. Enable ipv6 routing config# ipv6 unicast-routing 2. Assign your ipv6 address config-if# ipv6 add XXXX/XX 3. Configure Ripng and dont forget the string identification config# ipv6 router rip “string” 4. Enable Ripng on each interfaces. config-if# ipv6 rip “string”…
Read more
Packet Tracer lab example R1 interface Serial0/0/0 ip address 192.168.1.1 255.255.255.0 encapsulation frame-relay frame-relay map ip 192.168.1.2 102 broadcast frame-relay map ip 192.168.1.3 103 broadcast R2 interface Serial0/0/0 ip address 192.168.1.2 255.255.255.0 encapsulation frame-relay frame-relay map ip 192.168.1.1…
Read more
1. Enable frame relay switching on the frame relay sw 2. set the encapsulation to frame relay for each interface . 3. Set the frame-relay lmi type and intf . 4. Create the translation between each dlci with…
Read more
After many years of studies , i have learn many technologies and to make sure that i don’t forget any of it i have decided to make this site , so from time to time i will go back on everything…
Read more
1. Switch name change ERS55xx-Switch# conf t ERS55xx-Switch(config)# snmp-server enable ERS55xx-Switch(config)# snmp-server name “Avaya-ERS-Switch” 2. Assign IP address ERS55xx-Switch# conf t ERS55xx-Switch(config)# ip default-gateway 10.10.10.1 ERS55xx-Switch(config)# ip address switch 10.10.10.2 ERS55xx-Switch(config)# ip adress netmask 255.255.255.0 ERS55xx-Switch(config)# ip address source…
Read more
Rip is a Distance Vector protocol and use HOP Counts with a maximum of 15 and 16 is considerate to be infinite . RIP is an IGP interior Gateway Protocol Version : RIPv1 use broadcast and is classfull RIPv2 use…
Read more
