Patrick Denis > 2015 > March
Monthly Archive: March 2015
admin
March 20, 2015
OSPF Basic Authentication r1(config)#interface fastethernet x/x r1(config-if)#ip ospf authentication r1(config-if)#ip ospf authentication-key itss r2(config)#interface fastethernet x/x r2(config-if)#ip ospf authentication r2(config-if)#ip ospf authentication-key itss OSPF Encrypted Authentication r1(config)#interface fastethernet x/x r1(config-if)#ip ospf authentication message-digest r1(config-if)#ip ospf message-digest-key 1 md5 itss r2(config)#interface fastethernet x/x r2(config-if)#ip…
Read more
admin
March 20, 2015
OSPF Relations Requirement For two routers configured with OSPF to form a neighbor relationship, they must have interfaces that are either directly connected or connected to a multiaccess network media such as Ethernet. In addition, the IP addresses and subnet…
Read more
admin
March 12, 2015
IPV6 quick explanation 🙂 In this example the network show that there is 3 logical Sites : R1 Fa 0/0 2001:db8:1::/48 Fa 0/1 2001:db8:1::/48 R2 Fa 0/0 2001:db8:1::/48 Fa 0/1 2001:db8:1:/48 Se 0/0 2001:db8:2::/48 R3 Fa 0/0 2001:db8:1::/48 Fa 0/1…
Read more
admin
March 12, 2015
COMMAND SUMMARY 1. Configure loopback address on each router 2. Enable ipv6 routing 3. For static default route use ::/0 “XXXX:X:X:X::X 4. Configure the routing : ipv6 router ospf “Process ID” 5. Enable OSPFv3 on each interface . 6. Verify:…
Read more
admin
March 12, 2015
1. Enable ipv6 routing config# ipv6 unicast-routing 2. Assign your ipv6 address config-if# ipv6 add XXXX/XX 3. Configure Ripng and dont forget the string identification config# ipv6 router rip “string” 4. Enable Ripng on each interfaces. config-if# ipv6 rip “string”…
Read more
admin
March 12, 2015
Packet Tracer lab example R1 interface Serial0/0/0 ip address 192.168.1.1 255.255.255.0 encapsulation frame-relay frame-relay map ip 192.168.1.2 102 broadcast frame-relay map ip 192.168.1.3 103 broadcast R2 interface Serial0/0/0 ip address 192.168.1.2 255.255.255.0 encapsulation frame-relay frame-relay map ip 192.168.1.1…
Read more
admin
March 11, 2015
1. Enable frame relay switching on the frame relay sw 2. set the encapsulation to frame relay for each interface . 3. Set the frame-relay lmi type and intf . 4. Create the translation between each dlci with…
Read more
admin
March 10, 2015
After many years of studies , i have learn many technologies and to make sure that i don’t forget any of it i have decided to make this site , so from time to time i will go back on everything…
Read more